Back to Blog
Lattice trellis5/9/2023 ![]() Using a circular saw, cut four 1x1 strips to fit between the uprights.Because this sandwich of strip, lattice, and strip is thinner than the 2x4, it creates a stepped-down reveal between the frame and the lattice, which must be consistent all the way around when viewed from the front. ![]() The lattice panels that make up the climbing portion of the trellis float freely between two stops of 1x1s attached to the 2x4 frame.Assemble the Frame Trellis Photo by Kolin Smith Check the fit of each notch with a 2x4 it should be snug but not too tight.ĥ. Using a chisel, bevel side up, knock out the remaining wood between the kerfs.Using a handsaw or circular saw, make ¼-inch-deep kerf cuts, closely spaced together, between the marks.Tip: To be sure the two notches on either side of each frame are even, mark and cut them on both uprights at the same time, working with the lumber lined up side by side. If your trellis will have two or more attached panels, you'll need to notch both sides of the common uprights. Using a combination square, measure down ¼ inch along the sides of your markings to give you a guide for the depth of the notches.Repeat this marking at the top edge of the uprights. Lay a scrap 2x4 on edge-representing the width you want your notch to be-across the uprights at your mark, and, using a Speed Square, check that the scrap is square to the lumber. Lay both uprights flat, side by side, and flush at the ends.To locate the bottom notches, measure up from the end of the frame's two uprights a distance of one foot, plus the amount the posts will be buried, and mark the wood.Joining the lumber using a combination of notches and screws will make for a very strong and square frame. The horizontal 2x4s in the trellis frames meet the vertical pieces by butting into ¼-inch-deep notches.Locate and Mark Notches Photo by Kolin Smith Using a circular saw guided by a straightedge, cut panels from the lattice that are sized to fit inside the frames.Ģ.Using a circular saw guided by a Speed Square, cut the 2x4s to the lengths needed for the uprights and the horizontal members of each frame.For stability, you should also size them so that you'll be burying one-third of the trellis's total height. When sizing the frame's uprights, remember that they double as the posts, so they must be long enough to be buried deeper than the frost line in your region and still leave a 1-foot clearance between the frame and the ground (for cleanup). Design your trellis in proportion to its surroundings, keeping distances from architectural features-such as the eaves or windows on the house-consistent.Sunday: Dig holes set the trellis in place.Saturday: Build the three panels and join them together into one. ![]()
0 Comments
Read More
Leave a Reply. |